LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (I/P) Upper >> Installation Procedure

Installation Procedure

    Fig 1: Disconnecting Ambient Light Sensor Electrical Connector
    GM350507Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
    2. Fig 2: Removing I/P Assembly Upper Trim Panel
    GM348717Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the IP assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the trim panel retaining screws.

    Tighten:  Tighten the trim panel retaining screws to 2 N.m (18 lb in).

  4. Install the windshield pillar garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
    5. Fig 3: Removing Assist Handle
    GM348728Courtesy of GENERAL MOTORS CORP.
  5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
  6. Install the right side air outlets.
    7. Fig 4: Removing End Panel
    GM348724Courtesy of GENERAL MOTORS CORP.
  7. Install the end panels. The left panel is shown, and the right panel is similar.
  8. Install the IP cluster trim plate bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster .
  9. Tilt the steering wheel to the normal driving position.
  10. If the transmission is automatic, move the shift lever to the park position.
  11. Disengage the parking brake.
scientia non olet · About LEMON Manuals