Ignition Coil Module Installation - Right Side

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Spark Plug

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the right spark plugs and tighten to 15 N.m (11 lb ft).

Fig 2: Spark Plug Boots

Courtesy of GENERAL MOTORS CORP.

Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984), to each spark plug boot (1) of the ignition coil assembly.

Fig 3: Ignition Coil Assembly

Courtesy of GENERAL MOTORS CORP.

Carefully, install the right ignition coil assembly.

Fig 4: Ignition Coil Assembly Bolts & Ball Studs

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil assembly bolts (708) and ball studs (709).
Tighten the right ignition cassette bolts and ball studs to 10 N.m (89 lb in).

Fig 5: Ignition Coil Assembly Cover

Courtesy of GENERAL MOTORS CORP.

Install the right ignition coil assembly cover.