Ignition Coil Module Installation - Left Side

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Spark Plugs

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the left spark plugs and tighten to 15 N.m (11 lb ft).

Fig 2: Spark Plug Boots

Courtesy of GENERAL MOTORS CORP.

Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984), to each spark plug boot (1) of the ignition coil assembly.

Fig 3: Left Ignition Coil Assembly

Courtesy of GENERAL MOTORS CORP.

Carefully, install the left ignition coil assembly.

Fig 4: Left Ignition Coil Assembly Bolts & Studs

Courtesy of GENERAL MOTORS CORP.

Install the left ignition coil assembly bolts (708) and ball studs (709) to tighten to 10 N.m (89 lb in).

Fig 5: Ignition Coil Assembly Cover

Courtesy of GENERAL MOTORS CORP.

Install the left ignition coil assembly cover.