Generator Installation

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Generator & Bolts

Courtesy of GENERAL MOTORS CORP.

Place the generator in position to the generator bracket.

CAUTION: Refer to Fastener Caution .

Loosely install the generator bolts.
Tighten the generator bolts in proper sequence.
- Tighten the generator upper rear bolt to 50 N.m (37 lb ft) .
- Tighten the generator lower bolt to 50 N.m (37 lb ft) .
- Tighten the generator upper front bolt to 50 N.m (37 lb ft) .