LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> CTS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 3 Of 3) >> Engine Wiring Harness Assembly Installation >> Right Side Harness Connections

Right Side Harness Connections

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Right Side Fuel Injectors Engine Wiring Harness Connectors
    GM927838Courtesy of GENERAL MOTORS CORP.
  1. Connect the engine wiring harness to the right side fuel injectors.
    2. Fig 2: Right Camshaft Cover Engine Wiring Harness Connectors
    GM927778Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness to the right camshaft cover.
    3. Fig 3: Engine Wiring Harness & Right Ignition Coil Harness
    GM927822Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness to the right coil assembly harness.
    4. Fig 4: Right Camshaft Position Sensors Engine Wiring Harness Connectors
    GM927790Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness to the right camshaft position sensors.
    5. Fig 5: Intake Manifold Stud Engine Wiring Harness Ground
    GM927871Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness ground to the intake manifold stud.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the engine wiring harness ground nut and tighten to 10 N.m (89 lb in).
    7. Fig 6: ECT Sensor Engine Wiring Harness Connectors
    GM927819Courtesy of GENERAL MOTORS CORP.
  7. Connect the engine wiring harness to the ECT sensor at the rear of the right cylinder head.
    8. Fig 7: Generator Engine Wiring Harness Connectors
    GM1346050Courtesy of GENERAL MOTORS CORP.
  8. Connect the engine wiring harness to the generator.
    9. Fig 8: Starter Motor To Generator Wiring Harness Connector
    GM1346047Courtesy of GENERAL MOTORS CORP.
  9. Connect the starter motor wiring harness to the generator.
  10. Install the starter motor wiring harness generator nut and tighten to 10 N.m (89 lb in).
    11. Fig 9: MAP Sensor Engine Wiring Harness Connector
    GM927850Courtesy of GENERAL MOTORS CORP.
  11. Connect the engine wiring harness to the MAP sensor.
    12. Fig 10: Knock & Crankshaft Position Sensor Wiring Harness Engine Wiring Harness Connector
    GM927798Courtesy of GENERAL MOTORS CORP.
  12. Connect the engine wiring harness to the knock and crankshaft position sensor wiring harness.
    13. Fig 11: Engine Wiring Harness Bracket & Bolts
    GM1346053Courtesy of GENERAL MOTORS CORP.
  13. Install the engine wiring harness bracket to the side of the right cylinder head.
  14. Install the engine wiring harness bracket bolts and tighten to 45 N.m (33 lb ft).
scientia non olet · About LEMON Manuals