LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> CTS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 3 Of 3) >> Drive Belt Tensioner Installation >> P/S Pump and A/C Compressor Drive Belt Tensioner

P/S Pump and A/C Compressor Drive Belt Tensioner

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: P/S Pump & A/C Compressor Drive Belt Tensioner
    GM1346197Courtesy of GENERAL MOTORS CORP.
  1. Place the P/S pump and A/C compressor drive belt tensioner in position to the camshaft position actuator housing. Ensure to properly locate the dive belt tensioner anchor pin in the recess in the camshaft position actuator housing.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the P/S pump and A/C compressor drive belt tensioner bolt and tighten to 50 N.m (37 lb ft).
scientia non olet · About LEMON Manuals