LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> CTS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 618 (Automatic Transmission - 6L50/6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Output Shaft Seal Replacement (6L50 All Wheel Drive)

Transmission Output Shaft Seal Replacement (6L50 All Wheel Drive)

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Transmission Output Shaft Seal Replacement
GM1657043Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the exhaust system. Refer to Exhaust System Replacement .
  3. Remove the drive shaft. Refer to Rear Propeller Shaft Replacement (AWD) or Rear Propeller Shaft Replacement (RWD) .
  4. Support the transmission with a suitable jack.
  5. Remove the transmission mount assembly. Refer to Transmission Mount Replacement (All Wheel Drive)  or Transmission Mount Replacement (Rear Wheel Drive) .
  6. Remove the transfer case. Refer to Transfer Case Assembly Replacement .
1 Output Shaft Seal

Procedure

  • Use the J 45000  to remove the seal. Use care in order to avoid scraping or gouging the output shaft bushing.
  • Lubricate the seal with clean transmission fluid.
  • Use the J 38693  to install the seal. See Special Tools .

Tools Required

  • J 45000  Seal Remover
  • J 38693  Seal Installer. See Special Tools .
scientia non olet · About LEMON Manuals