Control Valve Body Assembly Installation
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | NEW Fluid Pump Seal Assembly |
| 2 | NEW Fluid Pump Seal Assembly |
| 3 | NEW Center Support Fluid Passage Seal Assembly |
| 4 | Control Valve Body Assembly Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin. |
| 5 | Bolts M5 x 73 (Quantity: 6)
NOTE:
Refer to Fastener Notice
.
Tighten: Tighten to 8 N.m (71 lb in) in the sequence shown. Special Tool: DT-48285 Valve Body Torx Plus Socket (if applicable). See Special Tools . |