LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Transmission Mount Replacement - Rear (w/AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission mount to the vehicle.
    2. Fig 1: View Of Transmission Mount
    GM888315Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transmission to support mounting bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

  3. Install the transmission mount to body mounting bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  4. Remove the transmission support.
  5. Install the exhaust system.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals