LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Transmission Fluid Cooler Pipe Replacement - Rear (w/AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine oil filter. Refer to Engine Oil and Oil Filter Replacement in Engine Mechanical - 4.6L.
  2. Remove the left hand (LH) intermediate shaft bearing assembly. Refer to Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle in Front Drive Axle.
    3. Fig 1: View Of TOC Lines
    GM1351420Courtesy of GENERAL MOTORS CORP.
  3. Using the J 44827  , disconnect the front transmission oil cooler (TOC) lines from the rear TOC lines.
    4. Fig 2: View Of TOC Lines & Transmission
    GM1334984Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear TOC line to transmission retainer bolt.
  5. Disconnect the rear TOC lines from the transmission.
  6. Remove and discard the O-rings.
    7. Fig 3: View Of TOC Retainer Bracket
    GM1334983Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Reposition the TOC lines to gain access to the retainer bracket rivets. The TOC lines must be removed individually.
  7. Remove the TOC retainer bracket bolt.
  8. Dill out the retainer bracket rivets.
  9. Remove the retainer bracket.
  10. Remove the TOC lines.
scientia non olet · About LEMON Manuals