LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Transmission Fluid Cooler Pipe Replacement - Rear (w/AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the TOC lines.
  2. Install the retainer bracket.
  3. Install the retainer bracket to the TOC lines.
  4. Rivet the retainer bracket to the TOC lines.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of TOC Retainer Bracket
    GM1334983Courtesy of GENERAL MOTORS CORP.
  5. Install the TOC retainer bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  6. Install new O-rings to the rear TOC lines.
  7. Connect the rear TOC lines to the transmission.
    8. Fig 2: View Of TOC Lines & Transmission
    GM1334984Courtesy of GENERAL MOTORS CORP.
  8. Install the rear TOC line to transmission retainer bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    9. Fig 3: View Of TOC Lines
    GM1351420Courtesy of GENERAL MOTORS CORP.
  9. Connect the front TOC lines to the rear TOC lines.
  10. Install the LH intermediate shaft bearing assembly. Refer to Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle in Front Drive Axle.
  11. Install the engine oil filter. Refer to Engine Oil and Oil Filter Replacement in Engine Mechanical - 4.6L.
scientia non olet · About LEMON Manuals