LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Transmission Fluid Cooler Pipe Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of TOC Retainer Clip
    GM1350216Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It is not necessary to discharge the refrigerant from the A/C system during auxiliary transmission oil cooler (TOC) front line replacement.
    Remove the A/C condenser mounting bolts and reposition the condenser.
  1. Reposition the condenser to access the auxiliary transmission oil cooler lines. Refer to Condenser Replacement (Heavy Duty Cooling) or Condenser Replacement (Standard Cooling) .
  2. Disconnect the transmission oil cooler (TOC) lines from the TOC.
  3. Disconnect the TOC line from the TOC retainer clip (1).
    4. Fig 2: View Of Transmission Oil Cooler Lines-To-Cooling Fan Shroud Retaining Bolts
    GM1351414Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts that connect the TOC to the cooling fan shroud.
    5. Fig 3: View Of TOC Lines
    GM1351420Courtesy of GENERAL MOTORS CORP.
  5. Remove the LH front wheel. Refer to Tire and Wheel Removal and Installation .
  6. Remove the LH front splash shield retainers.
  7. Remove the LH front splash shield.
  8. Using J 44827  , disconnect the front TOC lines from the rear TOC lines.
  9. Remove the front TOC lines.
scientia non olet · About LEMON Manuals