LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Torque Converter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Input Shaft Seal
    GM848536Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Take care to prevent cutting of the input shaft seal on the input shaft splines.
  1. Install the input shaft seal. Refer to Seal Replacement - Torque Converter .
    2. Fig 2: View Of Torque Converter
    GM792797Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the torque converter is fully seated into the transmission pump drive gear and turbine shaft.
  2. Install the torque converter. Push the torque converter into position while rotating.
    • The torque converter must be fully seated on the turbine shaft
    • The torque converter must be fully seated in the pump drive gear
  3. Install the transmission to the vehicle. Refer to Transmission Replacement (w/RPO LY7)  or Transmission Replacement (w/RPO LH2) .
scientia non olet · About LEMON Manuals