LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Shift Indicator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the shift control knob. Refer to Shift Control Knob Replacement .
    2. Fig 1: View Of Shift Control Trim Plate
    GM891692Courtesy of GENERAL MOTORS CORP.
  2. Remove the shift control trim plate by lifting the rear of the trim plate up then pull the plate rearward in order to disengage the front retaining tabs.
  3. Disconnect the electrical connectors from the shift control trim plate.
  4. Remove the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console
    5. Fig 2: View Of Shift Indicator Lamp Sockets & Shift Lock Control Pigtail Wiring Harness Connector
    GM891687Courtesy of GENERAL MOTORS CORP.
  5. Remove the shift indicator lamp sockets (1 and 2) from the shift indicator by rotating the lamp sockets one quarter turn.
    6. Fig 3: View Of Shift Indicator & Retaining Tabs
    GM892211Courtesy of GENERAL MOTORS CORP.
  6. Carefully spread the retaining tabs (3) enough to lift the back of the shift indicator (2) up past the retaining tabs (3).
  7. Carefully lift upward on the front of the shift indicator (2) in order to release the front retaining tabs (1)
  8. Remove the shift indicator (2) from the shift control assembly.
scientia non olet · About LEMON Manuals