LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Shift Control Linkage Replacement (RWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the shift lever in PARK.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: View Of Shift Control Linkage Rod & Adjustment Nut
    GM830370Courtesy of GENERAL MOTORS CORP.
  3. Remove the nut from the shift control linkage rod.
  4. Disconnect the shift control linkage rod from the shift control assembly.
    5. Fig 2: Identifying Shift Linkage
    GM785877Courtesy of GENERAL MOTORS CORP.
  5. Remove the manual shift shaft nut.
  6. Remove the shift control linkage from the vehicle.
scientia non olet · About LEMON Manuals