LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Pressure Control Solenoid (PCS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of PCS
    GM792778Courtesy of GENERAL MOTORS CORP.
  1. Install new O-ring seals (3-4) to the pressure control solenoid (1), if the O-rings were previously removed.
  2. Install the pressure control solenoid (1) into the control valve body.
    3. Fig 2: Locating Solenoid Retainer
    GM795835Courtesy of GENERAL MOTORS CORP.
  3. Install the pressure control solenoid retainer into the control valve body.
    4. Fig 3: View Of PCS & Electrical Wiring Harness Connector
    GM795921Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical wiring harness connector (2) to the pressure control solenoid (1).
  5. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals