LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> Extension Housing and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Flange & Components
    GM822505Courtesy of GENERAL MOTORS CORP.
  1. If equipped with rear wheel drive (RWD), remove the drive flange (2) and seal (3). Refer to Drive Flange and Seal Replacement .
  2. Place a suitable jack under the transmission pan in order to support the transmission.
  3. Remove the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  4. If equipped with all wheel drive (AWD), remove the transfer case. Refer to Transfer Case Assembly Replacement in Transfer Case - BW 4476.
  5. Place a drain pan under the extension housing.
    6. Fig 2: View Of Extension Housing
    GM801792Courtesy of GENERAL MOTORS CORP.
  6. Remove the extension housing bolts (35).
  7. Remove the extension housing (27) and seal (25).
  8. If equipped with AWD, remove the seal from the extension housing.
scientia non olet · About LEMON Manuals