LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 5L40-E/5L50-E - Introduction & Repair Instructions) >> Repair Instructions >> 1-2 Shift Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid pan. Refer to Automatic Transmission Fluid/Filter Replacement .
    2. Fig 1: View Of 1-2 Shift Solenoid & Electrical Wiring Harness Connector
    GM795919Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical wiring harness connector (2) from the 1-2 shift solenoid (1).
    3. Fig 2: Locating Solenoid Retainer
    GM795835Courtesy of GENERAL MOTORS CORP.
  3. Using a small screwdriver or pick, remove the 1-2 shift solenoid retainer from the control valve body.
    4. Fig 3: Exploded View Of 1-2 Shift Solenoid
    GM792793Courtesy of GENERAL MOTORS CORP.
  4. Remove the 1-2 shift solenoid (7) from the control valve body.
  5. Remove the O-ring seals (4-5) from the 1-2 shift solenoid (7) ONLY if the O-rings are cut or worn.
scientia non olet · About LEMON Manuals