LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.6L (LH2) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Replacement - Right (w/RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Engine Mount Retaining Nut - RWD
    GM1067556Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  3. Install the right engine mount bracket. Refer to Engine Mount Bracket Replacement - Right (w/RWD)  or Engine Mount Bracket Replacement - Right (w/AWD) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals