LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.6L (LH2) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Engine Mount Bracket
    GM888296Courtesy of GENERAL MOTORS CORP.
  1. Install the left engine mount brackets.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the left engine mount bracket retaining bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    3. Fig 2: View Of Left Engine Mount
    GM888298Courtesy of GENERAL MOTORS CORP.
  3. Install the upper engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  4. Remove the screw jack.
  5. Install the left exhaust manifold. Refer to Exhaust Manifold Removal - Left .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals