LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.6L (LH2) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Tensioner Replacement - Generator >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Generator Drive Belt Tensioner
    GM887841Courtesy of GENERAL MOTORS CORP.
  1. Position the generator drive belt tensioner and bolt to the engine as an assembly.
  2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  4. Install the generator drive belt. Refer to Drive Belt Replacement - Generator .
  5. Install the air conditioning, power steering, and water pump drive belt. Refer to Drive Belt Replacement - Air Conditioning, Power Steering and Water Pump .
scientia non olet · About LEMON Manuals