LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.6L (LH2) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the accessory drive belts. Refer to Drive Belt Replacement - Generator  and to Drive Belt Replacement - Air Conditioning, Power Steering and Water Pump .
  2. Remove the mechanical fan adapter, if equipped. Refer to Engine Cooling Fan Bracket Replacement (LH2) or Engine Cooling Fan Bracket Replacement (LY7) in Engine Cooling.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    4. Fig 1: View Of Flywheel Holder
    GM928040Courtesy of GENERAL MOTORS CORP.
  4. Remove the starter motor. Refer to Starter Motor Replacement (LY7) or Starter Motor Replacement (LH2) in Engine Electrical.
  5. Install the EN 46326  . See Special Tools .
    6. Fig 2: View Of Crankshaft Balancer Bolt
    GM928046Courtesy of GENERAL MOTORS CORP.
  6. Remove the crankshaft balancer bolt.
    7. Fig 3: View Of J 38416-2 & J 24420-C
    GM1346204Courtesy of GENERAL MOTORS CORP.
  7. Place the J 38416-2  crankshaft button into the end of the crankshaft.
  8. Install the J 24420-C  on the crankshaft balancer.
    9. Fig 4: View Of Crankshaft Balancer
    GM928051Courtesy of GENERAL MOTORS CORP.
  9. Remove the crankshaft balancer using the J 24420-C  .
scientia non olet · About LEMON Manuals