LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.6L (LH2) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Balancer
    GM928051Courtesy of GENERAL MOTORS CORP.
  1. Position the crankshaft balancer on the nose of the crankshaft.
    2. Fig 2: Pressing Crankshaft Balancer In Place Using J 41998-B
    GM948118Courtesy of GENERAL MOTORS CORP.
  2. Press the crankshaft balancer in place using the J 41998-B  .
    3. Fig 3: View Of Crankshaft Balancer Bolt
    GM928046Courtesy of GENERAL MOTORS CORP.
  3. Clean the crankshaft balancer bolt threads.
  4. Apply engine oil to the crankshaft balancer bolt threads.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the crankshaft balancer bolt.

    Tighten: 

    1. First Pass

      Tighten the bolt to 50 N.m (37 lb ft).

    2. Final Pass

      Tighten the bolt an additional 120 degrees using the J 45059  .

    6. Fig 4: View Of Flywheel Holder
    GM928040Courtesy of GENERAL MOTORS CORP.
  6. Remove the EN 46326  . See Special Tools .
  7. Install the starter motor. Refer to Starter Motor Replacement (LY7) or Starter Motor Replacement (LH2) in Engine Electrical.
  8. Install the mechanical fan adapter, if equipped. Refer to Engine Cooling Fan Bracket Replacement (LH2) or Engine Cooling Fan Bracket Replacement (LY7) in Engine Cooling.
  9. Install the accessory drive belts. Refer to Drive Belt Replacement - Generator  and to Drive Belt Replacement - Air Conditioning, Power Steering and Water Pump .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals