Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Applying Sealant To Split Line Of Right Cylinder Head & Camshaft Position Actuator Housing

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.

Install the camshaft cover gasket as required.
Place a small amount of sealant GM P/N 12345739 (Canadian P/N 10953541) or equivalent at the split line (1, 2) of the right cylinder head and the right camshaft position actuator housing.

Fig 2: View Of Right Camshaft Cover & Bolts

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Ground Strap, Right Camshaft Cover & Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the camshaft cover bolts installing the ground strap to the camshaft cover.
Tighten: Tighten the camshaft cover bolts to 10 N.m (89 lb in).
Install the ignition module. Refer to Ignition Control Module Replacement - Bank 1 in Engine Controls - 4.6L.

Fig 4: View Of PCV Dirty Air Breather Tube

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Fuel Injector Sight Shield/Top Cover

Courtesy of GENERAL MOTORS CORP.

Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .