LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 4.6L (LH2) (3 Of 6)) >> Repair Instructions (On-Vehicle - Part 2 And Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Valve Rocker Arm Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Roller Pivot Pocket (2) & Valve Slot Areas (1) Of Camshaft Followers
    GM235196Courtesy of GENERAL MOTORS CORP.
  1. Apply a liberal amount of lubricant GM P/N 12345001 or equivalent to the roller pivot pocket (2) and valve slot areas (1) of the camshaft followers.
    2. Fig 2: View Of Left Valve Rocker Arm
    GM928422Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.
  2. Place the camshaft followers in position on the valve tip and the SHLA. The rounded head of the follower goes on the SHLA, while the flat end goes on the valve tip.
  3. Install the left camshafts. Refer to Camshaft Replacement - Left .
scientia non olet · About LEMON Manuals