LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 4.6L (LH2) (3 Of 6)) >> Repair Instructions (On-Vehicle - Part 2 And Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Flywheel
    GM1346206Courtesy of GENERAL MOTORS CORP.
  1. Install the engine flywheel.
  2. Apply sealant, GM P/N 12346004 (Canadian P/N 10953480) or equivalent, to the engine flywheel bolts.
  3. Install the engine flywheel bolts finger tight.
  4. Use a Snap-On™ A144A Flywheel Turner, or equivalent to prevent the engine from rotating.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the engine flywheel bolts.

    Tighten: 

    • Tighten the flywheel bolts a first pass to 15 N.m (11 lb ft).
    • Tighten the flywheel bolts a final pass, an additional 50 degrees using the J 45059  .

  6. Install the transmission assembly. Refer to Transmission Replacement (w/RPO LY7) or Transmission Replacement (w/RPO LH2) in Automatic Transmission - 5L50-E.
scientia non olet · About LEMON Manuals