LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 4.6L (LH2) (3 Of 6)) >> Repair Instructions (On-Vehicle - Part 2 And Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Water Outlet Housing Removal

Water Outlet Housing Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Purge Valve Tube
    GM1254494Courtesy of GENERAL MOTORS CORP.
  1. Remove the EVAP purge valve tube from the EVAP purge valve.
    2. Fig 2: View Of Throttle Body Assembly
    GM927998Courtesy of GENERAL MOTORS CORP.
  2. Remove the throttle body bolts.
  3. Remove the throttle body from the water outlet.
    4. Fig 3: View Of Throttle Body Gasket
    GM1510042Courtesy of GENERAL MOTORS CORP.
  4. Remove and discard the throttle body gasket.
    5. Fig 4: Locating Intake Manifold Plenum Duct Clamp
    GM948138Courtesy of GENERAL MOTORS CORP.
  5. Loosen the clamp (1) on the intake manifold plenum duct.
    6. Fig 5: View Of Water Outlet Housing
    GM928004Courtesy of GENERAL MOTORS CORP.
  6. Remove the water outlet housing bolts.
  7. Remove the water outlet housing.
scientia non olet · About LEMON Manuals