LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 4.6L (LH2) (3 Of 6)) >> Repair Instructions (On-Vehicle - Part 2 And Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Crankshaft Balancer Removal

Crankshaft Balancer Removal

WARNING: This page is about a different variant/trim than selected.

Tools Required

    Fig 1: View Of Flywheel Holder
    GM928040Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46326  . See Special Tools .
    2. Fig 2: View Of Crankshaft Balancer Bolt
    GM1346203Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft balancer bolt.
    3. Fig 3: View Of J 38416-2 & J 24420-C
    GM1346204Courtesy of GENERAL MOTORS CORP.
  3. Place the J 38416-2  into the end of the crankshaft.
  4. Install the J 24420-C  on the crankshaft balancer.
    5. Fig 4: View Of Crankshaft Balancer
    GM1346205Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft balancer using the J 24420-C  .
scientia non olet · About LEMON Manuals