LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - BW 4476/79) >> Repair Instructions >> Transfer Case Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Exhaust System
    GM1215598Courtesy of GENERAL MOTORS CORP.
  1. Drain the transfer case fluid. Refer to Transfer Case Fluid Replacement .
  2. Remove the exhaust system. Refer to Exhaust System Replacement in Engine Exhaust.
  3. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear (AWD) or Propeller Shaft Replacement - Rear (RWD) in Propeller Shaft.
    4. Fig 2: Supporting Transmission With Jack & Block Of Wood
    GM830398Courtesy of GENERAL MOTORS CORP.
  4. Support the transmission with a suitable jack and a block of wood.
  5. Remove the transmission mount-to-body bolts.
    6. Fig 3: View Of Transmission Mount
    GM888315Courtesy of GENERAL MOTORS CORP.
  6. Remove the transmission mount-to-transmission bolts.
  7. Remove the transmission mount.
    8. Fig 4: View Of Propeller Shaft CV Joint-To-Transfer Case Flange Bolts
    GM850252Courtesy of GENERAL MOTORS CORP.
  8. Install a flat-bladed tool into the notch on the transfer case flange.
  9. Using the flat-bladed tool, carefully move the propeller shaft toward the front of the vehicle and remove the propeller shaft from the transfer case flange.
    10. Fig 5: Tying Front Propeller Shaft
    GM830393Courtesy of GENERAL MOTORS CORP.
  10. Using mechanics wire, tie the front propeller shaft up and out of the way.
    11. Fig 6: View Of Transfer Case
    GM830369Courtesy of GENERAL MOTORS CORP.
  11. Using a suitable adjustable jack, support the transfer case.
  12. Remove the transfer case bolts.
  13. Remove the transfer case.
scientia non olet · About LEMON Manuals