LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.6L (LH2) - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 1 (Right) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Intake Camshaft Position Actuator Solenoid
    GM1276389Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 4.6L (LH2).
  2. Disconnect the actuator solenoid electrical connector.
  3. Remove the right intake camshaft position (CMP) actuator solenoid bolts.
  4. Remove the right intake CMP actuator solenoid.
scientia non olet · About LEMON Manuals