Engine Oil Pressure Indicator Always On

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Engine Control Module (ECM) Connector End Views in Engine Controls - 3.6 L, Engine Control Module (ECM) Connector End Views in Engine Controls - 4.6 L or to Inline Harness Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Start the engine. Does the engine oil pressure indicator illuminate after the displays test?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement?	Go to Step 4	-
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2