Turbine Shaft/Overdrive Carrier Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 36850 Assembly Lubricant

Fig 1: Installing Overrun Clutch Housing Thrust Washer To Overrun Clutch Housing Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Be sure the overdrive assembly is fully engaged and is level with the fourth clutch housing.

Install the turbine shaft and overdrive assembly into the transmission case.
Install the overrun clutch housing thrust washer (218) onto the overrun clutch housing assembly (504). Retain with J 36850 or equivalent.

Fig 2: Checking Oil Pump Mating Surface & Overrun Clutch Housing Thrust Washer Surface

Courtesy of GENERAL MOTORS CORP.

Place a straight edge from the oil pump mating surface to the overrun clutch housing thrust washer (218). The 2 surfaces should be flush.