LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Automatic Transmission - 4L80-E/4L85-E - Overhaul) >> Repair Instructions >> Transmission Oil Pump Cover Disassemble

Transmission Oil Pump Cover Disassemble

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Reverse Boost Valve & Pressure Regulator Valve Components
    GM31191Courtesy of GENERAL MOTORS CORP.
    CAUTION: Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result.
  1. Remove the reverse boost valve bushing retainer ring (226) from the oil pump cover (206).
  2. Remove the reverse boost valve bushing (227).
  3. Remove the reverse boost valve (228).
  4. Remove the pressure regulator valve spring retainer (229).
  5. Remove the pressure regulator valve inner (238) and outer springs (230).
  6. Remove the pressure regulator valve (231).
  7. Remove the pressure regulator valve bore plug (232).
  8. Remove the pressure regulator valve bore plug pin (211).
  9. Inspect the pressure regulator valve components for chips, burrs, distortion, plugged oil passages.
    10. Fig 2: View Of Converter Regulator Valve Components
    GM31192Courtesy of GENERAL MOTORS CORP.
  10. Remove the converter regulator valve bore plug pin (211) from the oil pump cover (206).
  11. Remove the converter regulator valve bore plug (212).
  12. Remove the converter regulator valve spring (213).
  13. Remove the converter regulator valve (214).
  14. Inspect the converter regulator valve components for chips, burrs, and distortion.
    15. Fig 3: View Of TCC Enable Valve Components
    GM31193Courtesy of GENERAL MOTORS CORP.
  15. Remove the TCC enable valve spring retainer sleeve (215) from the oil pump cover (206).
  16. Remove the TCC enable valve spring (216).
  17. Remove the TCC enable valve (217).
  18. Inspect the TCC enable valve components for chips, burrs, and distortion.
    19. Fig 4: View Of TCC Shift Valve Components
    GM31194Courtesy of GENERAL MOTORS CORP.
  19. Remove the TCC shift valve bore plug retainer ring (221) from the oil pump cover (206).
  20. Remove the pressure regulator (TCC shift) valve bore plug (232).
  21. Remove the TCC shift valve (223).
  22. Remove the TCC shift valve spring (224).
  23. Remove the TCC shift valve spring seat (225).
  24. Remove the TCC shift valve spring seat pin (211).
  25. Inspect the TCC shift valve components for chips, burrs, and distortion.
  26. Inspect the oil pump cover vent hole for blockage.
  27. Inspect the stator shaft splines for damage.
  28. Inspect the turbine shaft bushings (233, 234) for wear, and galling.
    29. Fig 5: View Of Overrun Clutch Housing Oil Seal Rings
    GM31196Courtesy of GENERAL MOTORS CORP.
  29. Remove the overrun clutch housing oil seal rings (219) from the oil pump cover (206).
  30. Inspect the overrun clutch housing oil seal ring grooves for nicks, burrs, and debris.
scientia non olet · About LEMON Manuals