Third/Fourth Clutch Accumulator Housing Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 25025-5 Guide Pin

Fig 1: Installing J 25025-5, Control Valve Body Gasket & Spacer Plate

Courtesy of GENERAL MOTORS CORP.

Install the J 25025-5 into the control valve body bolt hole where the manual shaft detent roller and spring assembly is mounted.
Install the control valve body gasket (45).
Install the control valve body spacer plate (46).

Fig 2: Installing 3rd & 4th Clutch Accumulator Components

Courtesy of GENERAL MOTORS CORP.

Install the accumulator housing gasket (47).
Install the 3rd clutch accumulator piston spring (50). This spring is the longer of the 2 accumulator springs.
Install the 4th clutch accumulator piston spring (49).
Install the 3rd and 4th clutch accumulator housing (51) onto the control valve assembly (44).
Install the 6 3rd and 4th clutch accumulator housing bolts (53). Tighten the bolts finger tight and start from one end of the accumulator housing toward the opposite end.

Fig 3: Tightening 3rd & 4th Clutch Accumulator Housing Bolts In Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the 3rd and 4th clutch accumulator housing bolts (53) in the order shown.
Tighten: Tighten the bolts to 11 N.m (97 lb in).
Remove the J 25025-5 .