LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Automatic Transmission - 4L80-E/4L85-E - Overhaul) >> Repair Instructions >> Third and Fourth Clutch Accumulator Housing Disassemble

Third and Fourth Clutch Accumulator Housing Disassemble

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing 3rd Clutch Accumulator Piston, Housing & Seals
    GM40609Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply low pressure compressed air to the hole at the top of the accumulator housing to assist with the piston removal.
  1. Remove the 3rd clutch accumulator piston (405) from the 3rd and 4th clutch accumulator housing (51).
  2. Remove the 3rd clutch accumulator piston seals (404, 406).
  3. Inspect the 3rd clutch accumulator piston and seals for porosity, scoring, nicks, scratches and damage.
    4. Fig 2: Removing 4th Clutch Accumulator Piston Components
    GM40610Courtesy of GENERAL MOTORS CORP.
  4. Remove the 4th clutch accumulator piston pin retainer ring (402).
  5. Remove the 4th clutch accumulator piston (407) and pin (408).
  6. Remove the 4th clutch accumulator piston pin (408) from the 4th clutch accumulator piston (407).
  7. Remove the 4th clutch accumulator piston seal (404).
  8. Inspect the 4th clutch accumulator piston, pin and seal for porosity, scoring, nicks, scratches and damage.
scientia non olet · About LEMON Manuals