LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Automatic Transmission - 4L80-E/4L85-E - Overhaul) >> Repair Instructions >> Parking System Components Installation

Parking System Components Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Parking Pawl, Shaft, Retainer & Spring
    GM28421Courtesy of GENERAL MOTORS CORP.
  1. Install the parking pawl shaft (702) and the parking pawl (703).
  2. Install the parking pawl shaft retainer (704).
  3. Install the parking pawl spring (705).
    4. Fig 2: Installing Parking Pawl Shaft Hole Plug
    GM28422Courtesy of GENERAL MOTORS CORP.
  4. Apply sealer GM P/N 12345382 or equivalent, to the parking pawl shaft hole plug (701).
  5. Using a 5/16 inch diameter rod, install the parking pawl shaft hole plug (701).
    6. Fig 3: Assembling Manual Shift Shaft Detent Lever To Parking Pawl Actuator Assembly
    GM28423Courtesy of GENERAL MOTORS CORP.
  6. Assemble the manual shift shaft detent lever assembly (711) to the parking pawl actuator assembly (710).
  7. Install the parking pawl actuator assembly (710) over the parking pawl.
    8. Fig 4: Installing Manual Shift Shaft Components
    GM56531Courtesy of GENERAL MOTORS CORP.
  8. Install the manual shift shaft seal (707).
  9. Partially install the manual shift shaft (708).
  10. Install the manual shift shaft detent lever nut (712) onto the manual shift shaft (708).
  11. Fully install the manual shift shaft (708).
  12. Install the manual shift shaft pin (709) onto the manual shift shaft (708).
    13. NOTE: Refer to Fastener Notice in Cautions and Notices.
  13. Tighten the manual shift shaft detent lever nut (712).

    Tighten:  Tighten the nut to 24 N.m (18 lb ft).

    14. Fig 5: Locating Parking Pawl Actuator Bracket & Bolts
    GM28425Courtesy of GENERAL MOTORS CORP.
  14. Install the parking pawl actuator bracket (713).
  15. Install the parking pawl actuator bracket bolts (714).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

scientia non olet · About LEMON Manuals