Overdrive Carrier Assembly Assemble

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 36850 Assembly Lubricant

Fig 1: View Of Overrun Clutch Housing Thrust Bearing Assembly & Overdrive Carrier Assembly

Courtesy of GENERAL MOTORS CORP.

Install the overrun clutch housing thrust bearing assembly (513) into the overdrive carrier assembly (514). Retain with J 36850 or equivalent.

Fig 2: View Of Overdrive Carrier Pinion Gear Components

Courtesy of GENERAL MOTORS CORP.

Install one overdrive carrier pinion gear (518) and its roller bearings (517) and thrust washers (515, 516), into the overdrive carrier assembly (514) at the location marked at disassembly.
Install the overdrive carrier pinion gear pin (519).
Repeat steps 2 and 3 until all 4 pinion gear assemblies are installed in their original locations.

Fig 3: View Of Overdrive Carrier Pinion Gear Pin Retainer & Retaining Ring

Courtesy of GENERAL MOTORS CORP.

Install the overdrive carrier pinion gear pin retainer (520) on the overdrive carrier assembly (514). Align the pinion gear pins with the retainer slots.
Install the overdrive carrier pinion gear pin retainer retaining ring (521) on the overdrive carrier assembly (514).