Low and Reverse Band Servo Piston Pin Check

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 21370-10 Band Apply Pin Gage. See Special Tools .
J 38737 Band Apply Pin Checking Tool. See Special Tools .

Fig 1: Installing J 21370-10 Into Low & Reverse Band Servo Pin Bore

Courtesy of GENERAL MOTORS CORP.

Install the J 21370-10 into the low and reverse band servo pin bore. See Special Tools .
Position the J 38737 over the low and reverse band servo bore with the hex hub facing the parking pawl linkage. See Special Tools .

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fasten the J 38737 to the case with two low and reverse band servo cover bolts (61). See Special Tools .
Tighten: Tighten the bolts to 24 N.m (18 lb ft).
Verify that the J 21370-10 moves freely in the J 38737 and in the low and reverse band servo pin bore. See Special Tools .
In order to determine the correct low and reverse band servo piston pin length, tighten the hex hub of the J 38737 . See Special Tools .
Tighten: Tighten the hex hub of the J 38737 to 34 N.m (25 lb ft).
Observe the lands on the J 21370-10 in order to determine which land is even with the top edge of the J 38737 . Note the letter (A, B or C) stamped on the J 21370-10 . See Special Tools .
Refer to the LOW AND REVERSE BAND SERVO PISTON PIN SPECIFICATION CHART in order to determine the correct pin length to use.