LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Automatic Transmission - 4L80-E/4L85-E - Overhaul) >> Repair Instructions >> Low and Reverse Band Servo Assembly Installation

Low and Reverse Band Servo Assembly Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Low & Reverse Accumulator Piston Spring & Band Servo Assembly
    GM40606Courtesy of GENERAL MOTORS CORP.
  1. Install the low and reverse accumulator piston spring (74) into the transmission case.
    2. IMPORTANT: The low and reverse band servo assembly (64-73) is pushed down when tightening the cover bolts. Do not force the low and reverse band servo assembly (64-73) into the servo bore.
  2. Install the low and reverse band servo assembly (64-73).
    3. Fig 2: Installing Low & Reverse Band Servo Cover, Gasket & Bolts
    GM40607Courtesy of GENERAL MOTORS CORP.
  3. Install the low and reverse band servo cover gasket (63).
  4. Install the low and reverse band servo cover (62).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 6 low and reverse band servo cover bolts (61).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft) in an alternating pattern.

scientia non olet · About LEMON Manuals