LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Automatic Transmission - 4L80-E/4L85-E - Overhaul) >> Repair Instructions >> Fourth Clutch Assembly Installation

Fourth Clutch Assembly Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 GMC Yukon XL, 2005 GMC Sierra, 2005 GMC Savana Special, 2005 GMC Savana Camper Special, and 2005 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fourth Clutch Assembly
    GM335059Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Removal of the fourth clutch backing plate retainer ring, the fourth clutch backing plate, and the fourth clutch plates will ease assembly of the overrun clutch housing assembly.
  1. Remove the fourth clutch backing plate retainer ring (523) from the fourth clutch housing (529).
  2. Remove the fourth clutch backing plate (524).
  3. Remove the clutch plates (525, 526).
    4. Fig 2: View Of Fourth Clutch Housing
    GM335061Courtesy of GENERAL MOTORS CORP.
  4. Install the fourth clutch housing (529) into the transmission case assembly.
    5. Fig 3: Locating Fourth Clutch Housing Bolt
    GM31110Courtesy of GENERAL MOTORS CORP.
  5. Install a new fourth clutch housing bolt (26).
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Do not over torque the fourth clutch housing bolt (26).
  6. Tighten the fourth clutch housing bolt (26).

    Tighten:  Tighten the bolt to 23-26 N.m (17-19 lb ft).

scientia non olet · About LEMON Manuals