LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 GMC Yukon, 2005 Chevrolet Tahoe, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Selector Switch Electrical Connectors
    GM830158Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel (I/P) cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
  2. Using a flat-tipped screwdriver, gently pry the retaining clips open on the housing.
  3. Slide out the selector switch until the electrical connectors are accessible.
  4. Disconnect the selector switch electrical connectors (2, 3).
    5. Fig 2: Selector Switch & Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
  5. Remove the selector switch from the housing.
scientia non olet · About LEMON Manuals