LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 GMC Yukon, 2005 Chevrolet Tahoe, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transfer Case Shield & Bolts
    GM826834Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the transfer case shield, if equipped.
  2. Install the transfer case shield bolts, if equipped.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals