LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Transfer Case - NVG 246-NP8) >> Diagnostic Information and Procedures >> Transfer Case Shift Control Switch Inoperative >> Test Description

Test Description

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 GMC Yukon, 2005 Chevrolet Tahoe, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step tests the functionality of the mode switch.
Transfer Case Shift Control Switch Inoperative

Step Action Yes No
Schematic Reference:  Transfer Case Control Schematics  
Connector End View Reference:  Transfer Case Control Connector End Views  
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Install a scan tool.
  2. Start the engine.
  3. Place the transmission into Neutral.
  4. Set the park brake.
  5. Use a scan tool in order to observe the Commanded Mode Indicator parameter while selecting each of the Mode positions.
Does the state change with the selection of any of the mode positions?		 Go to Step 5  Go to Step 3 
3 Replace the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement .
Did you complete the repair?		 Go to Step 5  -
4 Replace the transfer case shift control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the repair?		 Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle in order to determine if the symptom has been corrected.
Is the symptom still present?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals