LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Transfer Case - NVG 246-NP8) >> Diagnostic Information and Procedures >> DTC C0359 >> Test Description

Test Description

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 GMC Yukon, 2005 Chevrolet Tahoe, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step tests for proper reference voltage to the transfer case shift control module on the 4WD low circuit.
  2. 3:  This step tests the 4WD low circuit for a short to voltage.
  3. 4:  This step tests the 4WD low circuit for an open or high resistance.
  4. 5:  This step repairs the 4WD low circuit for a short to voltage.
DTC C0359

Step Action Values Yes No
Schematic Reference:  Transfer Case Control Schematics  
Connector End View Reference:  Transfer Case Control Connector End Views  
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Turn the ignition OFF.
  2. Disconnect the transfer case shift control module.
  3. Turn the ignition ON, with the engine OFF.
  4. Measure the voltage between the 4WD low circuit harness and ground.
Is the voltage reading within the specified values?		 10-13.5 V Go to Step 3  Go to Step 4 
3 
  1. Disconnect the PCM.
  2. Measure the voltage between the 4WD low circuit harness and ground.
Is the voltage reading at the specified value?		 0 V Go to Step 7  Go to Step 5 
4  Test the 4WD low circuit for an open, a high resistance, or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 8  Go to Step 6 
5  Repair the 4WD low circuit for short to voltage. Refer to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 8  -
6 Replace the PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the repair?		 - Go to Step 8  -
7 Replace the transfer case shift control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the repair?		 - Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC set?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals