Engine Flywheel Installation
WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine flywheel.
- Install the engine flywheel bolts.
Tighten the fasteners following a criss cross pattern.
Tighten:
- Tighten the engine flywheel bolts to 40 N.m (30 lb ft) for the first pass.
- Tighten the engine flywheel bolts to 80 N.m (59 lb ft) for the second pass.
- Tighten the engine flywheel bolts to 100 N.m (74 lb ft) for the final pass.
IMPORTANT:
Make sure the flywheel is installed correctly. Engine Side is stamped on the flywheel to assist with installation.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.