Conditions for Running the DTC
WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
DTCs P0053, P0054, P0059, P0060, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0125, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0151, P0152, P0153, P0154, P0155, P0157, P0158, P0160, P0161, P0200, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1134, P1153, P1154 are not set.
Passive Test
- The engine is running.
- The Engine Run Time parameter is less than 13.5 minutes.
- This diagnostic runs one time per drive cycle once the above conditions are met.
Intrusive Test
- The Engine Run Time parameter is more than 13.5 minutes.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Engine Speed parameter is between 900-5,000 RPM.
- The MAF Sensor parameter is between 5-100 g/s.
- The Vehicle Speed parameter is between 24-131 km/h (15-82 mph).
- The Short Term FT Bank 1 and Bank 2 parameter is between -10 and +10 percent.
- The maximum number of intrusive attempts is less than 100.
- This diagnostic runs one time per drive cycle once the above conditions are met.