LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Automatic Transmission - 4L80-E/4L85-E - Introduction, Specifications & Repair Instructions) >> Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Fluid Cooler Hoses At Transmission
    GM396807Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission fluid cooler hoses to the vehicle.
  2. Install the transmission fluid cooler hoses to the transmission. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
  3. Install the transmission fluid cooler hoses to the retainer on the engine.
  4. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  5. Lower the vehicle.
    6. Fig 2: View Of Transmission Fluid Cooler Hoses At Radiator
    GM396808Courtesy of GENERAL MOTORS CORP.
  6. Install the transmission fluid cooler hose to the radiator. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
    7. Fig 3: View Of Transmission Fluid Cooler Hoses At Auxiliary Oil Cooler
    GM396817Courtesy of GENERAL MOTORS CORP.
  7. Install the transmission fluid cooler hose from the Auxiliary oil cooler. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
  8. Install the grille assembly. Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
scientia non olet · About LEMON Manuals