Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of EVAP Purge Tube At EVAP Pipe

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP purge tube at the EVAP pipe.
Connect the EVAP purge tube clip to the fuel rail bracket.

Fig 2: View Of EVAP Purge Tube At Purge Solenoid

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP purge tube at the purge solenoid.

Fig 3: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the fuel injector harness electrical connector (3).
Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.