Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.

Fig 1: View Of EVAP CVS Electrical Connector & CVS Bracket

GM1224403

Courtesy of GENERAL MOTORS CORP.

Remove the right side, rear bumper step pad. Refer to Step Pad Replacement - Top Rear Bumper in Bumpers.
Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Disconnect the EVAP canister vent solenoid (CVS) electrical connector (1).

Fig 2: View Of EVAP Canister & Quick Connect Fittings

GM1372543

Courtesy of GENERAL MOTORS CORP.

Disconnect the EVAP canister quick connect lines. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
Remove the EVAP canister bolt.
Lower the vehicle half way.

Fig 3: View Of EVAP Canister Bracket Nuts

GM1373032

Courtesy of GENERAL MOTORS CORP.

Loosen the EVAP canister bracket nuts (1).

Fig 4: Disengaging/Engaging Front Bracket Clip

GM1372958

Courtesy of GENERAL MOTORS CORP.

Using a flat bladed screwdriver, disengage the front bracket clip.

Fig 5: Disengaging/Engaging Rear Bracket Clip

GM1372960

Courtesy of GENERAL MOTORS CORP.

Using a flat bladed screwdriver, disengage the rear bracket clip.
Remove the EVAP canister.
Cap the EVAP lines in order to prevent possible EVAP system contamination.