Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disengaging/Engaging Rear Bracket Clip

Courtesy of GENERAL MOTORS CORP.

Remove the caps from the EVAP lines.
Install the EVAP canister.
Using a flat bladed screwdriver, engage the rear bracket clip.

Fig 2: Disengaging/Engaging Front Bracket Clip

Courtesy of GENERAL MOTORS CORP.

Using a flat bladed screwdriver, engage the front bracket clip.

Fig 3: View Of EVAP Canister Bracket Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the EVAP canister bracket nuts (1).
Tighten: Tighten the nuts to 25 N.m (18 lb ft).

Fig 4: View Of EVAP Canister & Quick Connect Fittings

Courtesy of GENERAL MOTORS CORP.

Raise the vehicle.
Install the EVAP canister bolt.
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
Connect the EVAP canister quick connecting lines. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .

Fig 5: View Of EVAP CVS Electrical Connector & CVS Bracket

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP CVS electrical connector (1).
Lower the vehicle.
Install the right side, rear bumper step pad. Refer to Step Pad Replacement - Top Rear Bumper in Bumpers.